Modules cannot be found with CoreS module after updating to Bullseye

[POlf]

Hello,

I currently have one DIO and AIO module connected to my Core S module with Bullseye. After setting it up in Pictory like shown below, I still get a

Module is NOT present, data is NOT available!!!

error message when I enter piTest -d in the console

pictory.png (175.61 KiB) Viewed 10344 times

piTest -d.png (16.02 KiB) Viewed 10344 times

When setting up the modules in Pictory, I did so by dragging the devices as they are setup physically, then File >> Save as Start-Config, Tools >> Reset Driver

Looking at the LED status on the modules, both DIO and AIO are stuck with the Power Led blinking red constantly. The pi bridges are connected properly and everything is wired properly. I've tried this before with Buster and everything is working without any issues. Everything is physically setup the same as when I was using Buster.

Any help is appreciated. Thanks in advance!

[stefanh]

Hello,

We have a similar case that is being discussed here in the forum.

viewtopic.php?t=4138

Regards
Stefan