unable to set few parameters via command line (piTest)

[bhuvanchandradv]

Hello!,

I'm trying to set the push pull configuration for the DO peripheral via piTest, the write to variable is successful but the functionality is not reflected. Its the same for the voltage range selection for DI. We need to configure this via command line.
Configuring from the web panel works as expected.

Do we need any special sequence of updating the values to set the configuration variables ?

This is important in our project since we intend to have a ROS bridge which is a C/C++ application.

[bhuvanchandradv]

Hello!,

Gentle remainder.

[Eduard]

Hi,
unfortunately it is not possible to change the configuration of the AIO, DIO modules with “piTest”.
To change the configuration successfully you have to edit "/var/www/pictory/projects/_config.rsc".