Modbus timing and timeouts

Topics about the Hardware of Revolution Pi
Post Reply
francescoizzi
Posts: 18
Joined: 17 Feb 2018, 12:10
Answers: 0

Modbus timing and timeouts

Post by francescoizzi »

Hi all,

i try to configure a revolutionPi3 to read RS485 High performance soil and subtrates moisture sensor but without success.

I configured the modbus rtu master in pictory as usual ... image below ...
Schermata 2019-02-14 alle 09.18.20.png
Schermata 2019-02-14 alle 09.18.20.png (334.54 KiB) Viewed 3549 times
the piTest always fail with 110 error:

piTest -r Modbus_Action_Status_1
1 Byte-Value of Modbus_Action_Status_1: 110 dez (=6e hex)
1 Byte-Value of Modbus_Action_Status_1: 110 dez (=6e hex)
1 Byte-Value of Modbus_Action_Status_1: 110 dez (=6e hex)
1 Byte-Value of Modbus_Action_Status_1: 110 dez (=6e hex)
1 Byte-Value of Modbus_Action_Status_1: 110 dez (=6e hex)

The strange thing is that with QmodBus installed on Raspberry i successful connect and read register... image below...
Schermata 2019-02-14 alle 09.34.59.jpg
Schermata 2019-02-14 alle 09.34.59.jpg (449.94 KiB) Viewed 3549 times
The register 15 is the sensor board temperature ... the read value is correct

Any suggestion ?
zhan
Posts: 52
Joined: 16 Apr 2019, 13:31
Answers: 0

Re: Modbus timing and timeouts

Post by zhan »

hi francescoizzi,

sorry for replying late.

https://revolution.kunbus.com/tutorials ... rect=en_US
in this document, the 110 is described as "CONNECTION TIMED OUT The slave did not respond fast enough or not at all. Check your configuration and wiring."
Maybe in your case it is just not fast enough, is it possible?

thanks.
Simon
Simon
Post Reply